Long Stitch Binding

In our last class we went over a classic bookbinding technique called the long stitch. First we cut down our text weight paper to make 20 sheets of 8 1/2 x 6 inch pieces grain shortNext we nestled four sheets together and folded 5 sections that were 4 1/4 x 6 inches.

We then cut down our cover paper to be 17 x 6 1/4, and then created the spine by measuring from the left 8 1/8 inches and folding and then 3/4 of an inch to the right and folding. Next, we placed all five sections inside the spine and scored 1/8 of an inch from the edges and folded the front and back flaps over. These flaps can be trimmed or left to give the book more weight.

We then created both a text jig and cover jig to put holes into the sections and the cover spine

Next we used seven lengths of thread and began sewing the last section into the bottom hole of the book, starting from the cover in.

We wove the thread up to the top of the section through the cover and then moved to the adjacent hole and came down the section and tightened the threaded sections, making sure to always pull towards the direction we were sewing. We next knotted the threaded needle with the tail of the thread and did a kettle stitch before moving on to the third section and weaving to the top.

At the top of the third section we did a kettle stitch to the previous loop of sections one and two, before moving on to sections four and five (which also had a kettle stitch in between sections)

At the end of section five we made a kettle stitch and tucked an inch of left over thread between the sections on the inside of the cover.

After creating our long stitch books, we looked over the completed monotype accordion books

We also looked at collographs and discussed the difference between intaglio (below the plate surface) and relief (above the plate surface) printing. We will be printing collographs in our next session.